It was time to rip out the old carpet to see what was underneath. After removing the seats, the seat bases were removed. It looked like one of the screws was close to the hull and not in the plywood floor area. Sure enough, the seat base was screwed to the hull! Guess we'll have to fix that. After alot of vacuuming, I could finally see the wood floor. It seemed a little soft, but I will tackle that later. I was also able to see what the transom area looked like from the inside. I think it has been beefed up pretty well. Bigger motor maybe???
Hole in hull from seat screw
Battery area
Floor without Carpet
Control Area
Wiring and Control cables along starboard side
Steel plates in the transom
Mess of wires around battery compartment
No comments:
Post a Comment